Magnavox MDR868H Owner's Manual page 25

Network Function
MDR868/867H
11
Select "Use" or "Do Not Use" using [ K/ L ],
then press [ OK ].
• If you Select "Use", "Standby Setting" will be "Normal
Standby" automatically. 'Unit Name' screen will
appear.
• If you Select "Do Not Use", please move on to 'fun-Link
(HDMI CEC)'.
Unit Name
MDR868/867H
12
Select "Yes" or "No" using [ K/ L ], then
press [ OK ].
• If you Select "Yes", Unit Name Input Screen will
appear.
Enter the new Unit Name using the On-screen
Software Keyboard.
If you finish entering the Unit Name, press [ OK ].
• ''fun-Link (HDMI CEC)' screen will appear.' screen
will appear.
fun-Link (HDMI CEC)
When this unit and TV are connected via HDMI Cable, it is
possible to use the fun-Link(HDMI CEC) function.
This function may not work properly depending on the TV
connected to this unit.
13
Select "Yes" or "No" using [ K/ L ], then
press [ OK ].
• If you Select "Yes", "Standby Setting" will be "Normal
Standby" automatically.
• 'Standby Setting' screen will appear.
Standby Setting
14
Select "Normal Standby" or "Energy Saving
Standby" using [ K/ L ], then press [ OK ].
• If you Selected "Yes" for '''fun-Link (HDMI CEC)'
screen will appear.' screen will appear.' the unit is in
"Normal Standby" mode where the unit Starts Faster
than "Energy Saving Standby".
"Normal Standby" will increase the Power
Consumption when the Power is Off in Standby mode.
• If you did not select '''fun-Link (HDMI CEC)' screen
will appear.' screen will appear.' then you can select
"Normal Standby or "Energy Saving Standby", where
HDMI CEC and Network Functions (never available
in MDR865H) will be not available. "Energy Saving
Standby" will reduce the Power Consumption during
Standby mode rather than "Normal Standby".
• 'FL Dimmer' screen will appear
FL Dimmer
15
Select a desired item using [ K/ L ], then
press [ OK ].
Front Panel Display gets Darker when
Auto
the unit turned Off.
Front Panel Display gets Brighter.
Bright
Front Panel Display gets Darker.
Dark
In Power-On mode, panel lighting in On.
Off
In Standby mode, panel lighting is Off.
• 'Exit' screen will appear.
16
Select "Completed" using [ K/ L ], then
press [ OK ].
• "Initial Setting" is finished.
■
Guide to the Software Keyboard
1. Press [ the Number buttons ] Repeatedly to enter the
Desired Character.
• If a Desired Character is the same button as the Previous
Character, press [ 1 (Cursor)], then press the same
button.
• To change the Number Set, press [ INFO ].
To change the Character Set, press [ INFO ].
• To Delete Characters, press [ CLEAR ]
2. When you finish entering Numbers, Letters and
Characters, then press [ OK ].
Note(s)
• In Character Set, the Number 1 pushed Repeatedly can
be used to Input the following Symbols,
– ., @, -, _, /, :, !, ", #, $, %, &, ', (, ), *, +, ,, ;,
<, =, >, ?, [, \, ], ^, `, {, |, }, ~
Exit
EN - 25
EN