Gateway E-1600 System Manual page 48

6
Remove the five retaining screws.
Back
7
Squeeze the top of the standoff in the front left corner of the system board
to allow the board to slide off of the standoff.
8
Slide the system board toward the front of the chassis to disengage the
I/O connectors from the back panel.
9
Slide the system board toward the left side of the chassis to clear the fan
on the power supply, then lift the system board out of the chassis.
10
Remove the memory from the old system board and place it in an
anti-static bag.
To install the system board:
1
Install the memory from the old system board in the new system board.
2
Holding the system board by the top and bottom edges, slide it into the
case from the left side of the chassis.
40
Replacing and Adding System Components
Front
Standoff