Handset settings
Telephone settings
Set date/time
The answering system announces the date and time of the message prior
to playing it. Before using the answering system, set the date and time as
follows. If you subscribe to caller ID service, the day, month and time are set
automatically with each incoming call. However, the year must be set so that
the day of the week can be calculated from the caller ID information.
Follow the steps below to set the month, day, year and time.
1. When the handset is in the idle mode, press MENU/
to enter the main menu.
2. Press qCID or DIRp to scroll to >SET DATE/TIME, then
/SELECT.
press
MENU
3. Press qCID or DIRp to select the month, or enter the
correct number using the dial pad, then press
to confirm.
4. Press qCID or DIRp to select the day, or enter the correct
number using the dial pad, then press
confirm.
5. Press qCID or DIRp to select the year, or enter the correct
number using the dial pad, then press
confirm.
6. Press qCID or DIRp to select the hour, or enter the correct
number using the dial pad, then press
confirm.
7. Press qCID or DIRp to select the minute, or enter the
correct number using the dial pad, then press
to confirm.
8. Press qCID or DIRp to select the AM or PM, then press
confirm. There is a confirmation tone.
NOTE: If the clock was not set when a message is recorded, the system announces "Time and
day not set" before the message is played.
MENU
/SELECT to
MENU
/SELECT to
MENU
/SELECT to
MENU
MENU
11
SELECT
>ANS. SYSTEM
DIRECTORY
/SELECT
>SET DATE/TIME
CLR VOICEMAIL
SET DATE
--/--/--
SET TIME
--:-- --
/SELECT
/SELECT to
MENU