Sleep Operation - Sharp CD-DVD500H Operation Manual

Timer operation (continued)
CD-DVD500H
6
Press the TUNING/TIME (W W W W W or X X X X X ) button to specify the minutes, then press
the MEMORY/SET button.
7
The unit will enter the timer stand-by mode automatically.
To cancel the timer playback/timer recording:
Press the ON/STAND-BY button to turn the power on.
8
When the preset time is reached, playback or recording will start.
The volume will increase gradually until it reaches the volume you were listening
at before your system enters the timer stand-by mode.
The TIMER indicator will flash.
9
In timer playback:
If you select DVD, CD or TAPE, the unit will enter the stand-by mode after 1 hour.
When DVD, CD or TAPE playback is finished before 1 hour, the unit will enter the
stand-by mode at that time. If you select TUNER or VIDEO/AUX, it will enter the
stand-by mode 1 hour after the timer playback starts.
In timer recording:
When recording tape reaches its end, the timer recording will end, and the unit will
enter the stand-by mode.
The timer playback/timer recording setting will be cancelled if any other operation
than volume control is performed during its operation.
To reset or change the timer setting:
Perform "Timer playback or Timer recording" from the beginning.
Notes:
Once the time is set, the setting will be retained until a new time is entered.
When performing timer playback or recording using another unit connected to the
VIDEO/AUX IN sockets, select "VIDEO/AUX" in step 2. At this time, only this unit
will be turned on or enter the power stand-by mode automatically. (Another unit will
not be turned on or off.)
DVD timer playback may not be possible with some discs.
68 ENGLISH

Sleep operation

The radio, DVD, compact disc and cassette tape can all be turned off automatically.
Sleep operation
1
Play back the desired sound source.
2
Press the TIMER/SLEEP button repeatedly until "SLEEP" is displayed.
To change the sleep time:
Whilst the sleep time is displayed, press the TUNING/TIME (X or W) button.
(Maximum: 3 hours - Minimum: 1 minute)
3 hours - 5 minutes 5-minute intervals
5 minutes - 1 minute 1-minute intervals
3
Press the MEMORY/SET button.
4
Your system will enter the power stand-by mode automatically after the pre-
set time has elapsed.
The volume will be turned down 1 minute before the sleep operation finishes.
To cancel the sleep operation:
Press the ON/STAND-BY button whilst sleep timer is set.
To confirm the remaining sleep time:
Press the TIMER/SLEEP button whilst sleep timer is set.
The remaining sleep time is displayed for about 5 seconds.
Note:
Once the sleep time is set, it will remain unchanged until a new time is entered.