Listening To The Radio - Sharp CD-DVD500H Operation Manual

Listening to the radio

1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER (BAND) button repeatedly to select the desired
frequency band (FM or AM).
3
Press the TUNING/TIME (X X X X X or W W W W W ) button to tune in to the desired
station.
Manual tuning:
Press the TUNING/TIME button until tuning in to the desired station.
Auto tuning:
When the TUNING/TIME button is pressed for more than 0.5 seconds, scan-
ning will start automatically and the tuner will stop at the first receivable broad-
cast station.
Notes:
When radio interference occurs, auto scan tuning may stop automatically at
that point.
Auto scan tuning will skip weak signal stations.
To stop the auto tuning, press the TUNING/TIME button again.
When an RDS (Radio Data System) station is tuned in, the frequency will be
displayed first, and then the RDS indicator will light. Finally, the station name
will appear.
Full auto tuning can be achieved for RDS stations "ASPM", see page 57.
To receive an FM stereo transmission:
Press the TUNER (BAND) button so that the "ST" indicator lights up.
"j" will appear when an FM broadcast is in stereo.
If the FM reception is weak, press the TUNER (BAND) button so that the "ST" indi-
cator goes out. The reception changes to monaural, and the sound becomes clearer.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
CD-DVD500H
FM stereo mode indicator
FM stereo receiving indicator
ENGLISH 53
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15