Table of Contents
Advertisement
4358-3775B Scenera OHB
5/30/06
Locking Clip
NOTE:
Remove the locking clip when the seat belt is not
being used with a child restraint. The locking clip is located
on the back of the
seat.A locking clip will not fix all types
of seat belt problems.
Before you put your child restraint in the vehicle, buckle the
lap/shoulder belt. Pull on the lap belt portion. If it loosens or
slips, you must either use a locking clip to hold the seat belt
tight or move the child restraint to another seating location.
1
2
22
2:09 PM
Page 25
Thread both vehicle lap
and shoulder belts through
the slot (as shown) and
out other side. Buckle.
Pull up on shoulder belt
until all slack is out and lap
belt is tight.
Grasp both vehicle belts
together just behind the
buckle plate and unbuckle.
NOTE:
If the buckle plate
ends up behind the child
restraint, grasp the belts to
the outside of the child
restraint, as close to the
buckle plate as possible.
Thread both portions of
3
the vehicle belt onto the
locking clip.
Position locking clip about
4
1 in. (2.5 cm) from vehicle
belt's buckle plate.
Rebuckle belt. Lap belt
5
portion should now be
tight. If not, remove
locking clip and repeat all
steps.
23
Advertisement
Table of Contents
