DJG Scenera Versa-Fit Overhead Barrier Instruction Manual page 17

4358-3775B Scenera OHB 5/30/06
Rear-Facing Installation with
LATCH: Install in Vehicle
1
2
3
2:09 PM Page 33
Connect and tighten
harness straps prior to
installing in vehicle.
Place child restraint rear-
facing in the back seat.
With child restraint in the
reclined position, make
sure level line on side of
shell is level with ground.
Adjust child restraint if
needed.
NOTE: Hook the top
anchorage strap's hook to
recline stand.
Fasten one LATCH belt
hook to the anchor in the
vehicle seat located in the
vehicle seat bight. Repeat
for other side of child
restraint. See your vehicle
owner's manual for more
information.
Push down firmly on the
child restraint and pull up
on the loop to tighten belt.
30
With weakest hand at
4
belt path, tilt and push
the child restraint
forward and back, and
from side to side. If the
LATCH belts do not
loosen, your child
restraint should be
secure.
NOTE:
from front to back or
about an inch from side to side is acceptable.
If the child restraint does not remain tight, do not use
the child restraint in this seating location with this
LATCH system.
After checking for hot
5
seat and buckles, place
child in child restraint.
See "Securing Your Child
in the Child Restraint"
section.
To release LATCH:
Remove child from
restraint. Press down
firmly on adjuster side of
child restraint and push
in on release button on
adjuster to release
tension as shown.
Unhook LATCH from
bar.
WARNING
!
LATCH hooks MUST be securely
fastened. Failure to do this can result in
serious injury or death.
31
Some "play"