SmartRG SR350N User Manual page 29

Click Next after completing the necessary fields.
The individual fields on this screen are defined as follows:
Field Name
PPP Username:
PPP Password:
PPPoE Service Name:
Authentication Method
CP Keepalive Period
LCP Retry Threshold
Dial on Demand
PPP IP Extension
Advanced DMZ
Use Static IPv4 Address
Retry PPP password on
authentication error
Enable PPP Debug Mode
Bridge PPPoE Frames Between
WAN and Local Ports
Enable Firewall
Enable NAT
-Enable Fullcone NAT
-Enable SIP
Enable IGMP Multicast Proxy
No Multicast VLAN Filter
MTU size
Use Base MAC Address on this
WAN interface
ADDITIONAL OPTIONS WHEN
IPV4&IPV6 or IPV6 Only are
selected at the WAN Service
Creation Page
SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2014
Description
Enter the Username required for authentication to the PPP server.
Enter the Password required for authentication to the PPP server.
(Optional) Enter a description for this service.
Select a means for authentication from the drop-down list.
[AUTO] Attempt to AUTO detect handshake protocol in list below.
[PAP] Password Authentication Protocol (plaintext passwords)
[CHAP] Challenge Handshake Authentication Protocol. (MD5 hashing scheme on passwords)
[MSCHAP] Microsoft Challenge Handshake Authentication Protocol. (Microsoft encrypted password
authentication protocol)
The frequency with which the keepalive packet is sent by the gateway to the PPP server.
In the event that the PPP server does not respond to the Keepalive, how many additional attempted packets
will the gateway send before giving up and declaring the connection, Failed.
[1-4320] Enables Inactivity Timeout (minutes). Default = 0 (not applicable.)
Connection automatically starts when there is outbound traffic to the Internet. It automatically terminates if
the connection is idle based on the value in the Idle Timeout setting.
Forward all traffic to Advanced DMZ IP specified in the next field.
Only applicable if PPP IP extension is selected. Specify IP to forward traffic PPPoE traffic to.
Specify IPv4 Address to apply to WAN service.
[1-65536] Max PPP authentication retries on failure. (65536=Forever)
The system will put more PPP connection information into the system log of the device. This is for debugging
errors and not for normal usage.
PPPoE passthrough to relay PPPoE connections from behind the modem. Also known as Half-Bridged mode.
Enables functions in the Security sub-menu
Enable sharing the WAN interface across multiple devices on the LAN. Also enables the functions in the NAT
sub-menu and addition PPPoE NAT features to select.
Enables what is known as one-to-one NAT. (Exposed when Enable NAT is checked.)
Enables Session Initiation Protocol (SIP) pass-through NAT. Used for Voice over IP (VOIP) applications.
(Exposed when Enable NAT is checked.)
Enables Internet Group Membership Protocol (IGMP) multicast. Used by IPv4 hosts to report multicast group
memberships to any neighboring multicast routers.
Disables multicast filtering between WAN and LAN (VlanMux) network.
[1370-1492] Edit the Maximum Transmission Units (MTU) for PPP service.
Use SmartRG Devices Base (Primary) MAC address. When unchecked a unique MAC per service is assigned.
Enable IPv6 Unnumbered Model
Enable IPv6 Unnumbered Model
Launch Dhcp6c for Address Assignment (IANA)
Launch Dhcp6c for Prefix Delegation (IAPD)
Enable MLD Multicast Proxy
28