10
Getting started
Setting up the WLAN Handset
This section describes the following initial setup options for your WLAN Handset:
•
"Select Ring Type" on page 10
•
"Select Noise Mode" on page 11
•
"Enter Extension" on page 11
•
"Set up Push-to-Talk" on page 12
•
"Adjust ringer volume" on page 12
•
"Adjust speaker volume" on page 12
•
"Silence the ringer" on page 13
Select Ring Type
The Ring Type option enables you to set the WLAN Handset ring tone for the three different
ringers: Telephone, Auxiliary 1, and Auxiliary 2. Auxiliary 1 and Auxiliary 2 are reserved for
future use.
Select the Ring Type:
1
Press
2
Press the Up and Down buttons to scroll through the menu and highlight
3
Press the Select button (or
4
Press the Up and Down buttons to scroll through the menu and highlight
5
Press the Select button (or
6
Press the Up and Down buttons to scroll through the menu and highlight one of the following
settings:
•
Normal: Produces an audible ring (default).
•
Vibrate: Vibrates.
•
Vib/Norm: Vibrates for six seconds, then rings.
Press the Select button (or OK) to select the setting.
7
8
Do one of the following:
Press UP to return to the previous menu and set another option.
•
•
Press
You can also press Exit from the top-level menu to exit the menu and return to the active
(off-hook) state.
N0009103 2.0
when in the standby state.
OK
) to select
OK
) to select
to exit all menus and return to the standby state.
Ring Type
.
Telephone
.
Ring Type
.
Telephone
.