Slide Runner Inspection - Yamaha RX10K Supplementary Service Manual

A
B
6
TRACK TENSION ADJUSTMENT/

SLIDE RUNNER INSPECTION

7
Track alignment
Left adjuster
4
5 Right adjuster
8 Slide runner
10 Track metal
A RX10, RX10S , RX10R, RX10RS
B RX10M, RX10MS
c. Adjust the track deflection until the specified
amount is obtained.
Track deflection
Left adjuster
4
5
Right adjuster
CAUTION:
The adjusters should be turned an equal
amount.
S Recheck the alignment and deflection. If
necessary, repeat steps (a) to (c) until the
specified amount is obtained.
S Tighten the rear axle nut.
Nut (rear axle):
75 Nm (7.5 mSkg, 54 ftSlb)
SLIDE RUNNER INSPECTION
1. Inspect:
S Slide runner 1
Cracks/damage/wear ! Replace.
2. Measure:
S Slide runner thickness a
Out of specification ! Replace.
Slide runner wear limit:
10 mm (0.39 in)
2-37
INSP
ADJ
Shifted Shifted
6 7
to right to left
Turn out Turn in
Turn in Turn out
9 Track
11 Gap 12 Forward
More than Less than
specified specified
Turn in Turn out
Turn in Turn out