Yamaha RX10K Supplementary Service Manual page 464

STEERING
7. Adjust:
S Handlebar
Adjustment steps:
S Temporarily install the handlebar.
S Install the steering linkage alignment plate
3 .
Steering linkage alignment plate
90890-01487, YS-01487
S Loosen the locknuts (steering shaft) 1 .
S Turn the steering shaft 2 clockwise or coun-
terclockwise and then secure the handle bar
in the straight position.
Turning the steering
shaft in direction
Turning the steering
shaft in direction
S Tighten the locknuts (steering shaft) 1 .
Locknut (steering shaft):
25 Nm (2.5 mSkg, 18 ftSlb)
LOCTITE
S Remove the steering linkage alignment plate
3 .
8. Install:
S Toe-out
S Refer to "STEERING SYSTEM" in CHAP-
TER 2.
19
CHAS
Turning the
handlebar in
a
direction c
Turning the
handlebar in
b
direction
d