HEADLIGHT BEAM ADJUSTMENT
ELECTRICAL
HEADLIGHT BEAM ADJUSTMENT
1. Place the machine on a level surface.
2. Place the machine in front of a wall at the rec-
3. Measure the distance H from the floor to the
4. With a person sitting on the machine, apply
5. Switch on the headlight's high beam and
D : Distance
6. Adjust:
S Headlight beam (vertically)
2-43
ommended distance D . Refer to the table
below.
center of the headlight and place a mark on
the wall at that height.
the parking brake, start the engine and let it
idle.
check the height of the projected beam on
the wall. The projection should be at the posi-
tion marked in step 3 or 1/2_ lower (set range
S ).
D
3.0 m (10 ft)
S
26 mm (1.0 in)
S : Set range
Vertical adjustment
Higher Turn the adjusting screw
clockwise.
Lower Turn the adjusting screw
counterclockwise.
INSP
ADJ
7.6 m (25 ft)
66 mm (2.6 in)
1
1