Yamaha RX10K Supplementary Service Manual page 508

Brake hose
31
32 Fuel sender lead coupler
33 Set the coupler in the rear
space of the instrument panel
34 Clamp the ignition coil lead un-
der the fuel hose.
35 Clamp the fuel hose.
36 There should be no slack of
leads.
37
Clamp the throttle position
switch lead.
38
Route the coolant hose be-
tween the upper vacuum hose
and lower vacuum hose.
39
Route the vacuum hose under
the coolant hose.
40
Route the vacuum hose over
the coolant hose.
41 Clamp the coolant hose and
vacuum hose.
42 Clamp the coolant hose and
vacuum hose 2.
43 Throttle position sensor lead
coupler. (under the vacuum
hose)
44 Drive guard bracket
45 Connect the battery negative
lead to the starter motor mount-
ing bolt.
46 Voltage regulator
47
Carburetor heater relay
48
Headlight relay
49
Main relay
50
Back buzzer (RXW10J, RXW
10SJ)
51
Flange nut
52
Hexagon bolt
CABLE ROUTING
63
SPEC