Sony MHC-NX300AV Operating Instructions Manual page 5

1
Connect the flat cord to the SYSTEM
CONTROL connectors until it clicks.
To disconnect the system cable, push the
tab and pull it out.
2
Connect the front speakers.
Connect the speaker cords to the FRONT
SPEAKER jacks as below.
Insert only the stripped portion.
Red/
Solid (3)
Note
Keep the speaker cords away from the
aerials to prevent noise.
3
Connect the rear speakers.
Connect the speaker cords to the REAR
SPEAKER jacks.
Insert only the stripped portion.
Gray/
Solid (3)
Notes
• Keep the speaker cords away from the
aerials to prevent noise.
• Be sure to connect both left and right
rear surround speakers. Otherwise,
the sound will not be heard.
Black/
Stripe (#)
Black/
Stripe (#)
4
Connect the centre speaker.
Connect the speaker cords to the
CENTER SPEAKER jacks.
Insert only the stripped portion.
Gray/
Solid (3)
Note
Keep the speaker cords away from the
aerials to prevent noise.
5
Connect the FM/AM aerials.
Set up the AM loop aerial, then
connect it.
Jack type A
AM loop aerial
Jack type B
AM loop aerial
Note
Set up the AM loop aerial as far as possible from the
main unit.
Black/
Stripe (#)
Extend the FM lead
aerial horizontally.
A M
F M
7 5
Ω
C O
A X I
A L
Extend the FM lead
aerial horizontally.
A M
F M
7 5 Ω
continued
5