Sony MHC-NX300AV Operating Instructions Manual page 12

Step 4: Presetting radio stations
(continued)
To tune in a station with a weak
signal
Press + or – repeatedly in step 2 to tune in the
station manually.
To set another station to an
existing preset number
Start over from step 1. After step 3, turn the
jog dial to select the preset number where
you want to store the other station.
You can add a new preset number after the
last preset number.
To erase a preset station
1 Keep pressing TUNER MEMORY until a
preset number flashes in the display.
2 Turn the jog dial to select the preset
number you want to erase.
Select "ALL ERASE" when you want to
erase all the preset stations.
3 Press ENTER.
"COMPLETE!!" appears.
When you erase a preset number, the preset
number decreases by one and all preset
numbers following the erased one are
renumbered.
To change the AM tuning interval
The AM tuning interval is factory-preset to 9 kHz
(10 kHz in some areas). To switch the AM tuning
interval, tune in any AM station first, then turn off
the power. While holding down TUNER MEMORY,
press ?/1 to turn the power back on. When you
change the interval, AM preset stations are erased.
To switch back to the original interval, repeat the
same procedure.
Tip
The preset stations are retained for half a day even if
you disconnect the power cord or a power failure
occurs.
12
TUNED
STEREO