Sony MHC-NX300AV Operating Instructions Manual page 38

Programming the CD tracks
(continued)
1
Press CD, then place a CD.
2
Press PLAY MODE repeatedly until
"PROGRAM" appears in the
display.
3
Press one of the DISC 1~5 buttons to
select a CD.
4
Turn the jog dial until the desired
track appears in the display.
3
PROGRAM
5
Press ENTER.
The track is programmed. The
programme step number appears
followed by the total playing time.
PROGRAM
The last programmed track
*
"--.--" may appear in the case of SUPER
VIDEO CD.
6
To programme additional tracks,
repeat steps 3 to 5.
Skip step 3 to select tracks from the
same disc.
7
Press H.
All the tracks play in the order you
selected.
38
Disc number
Track number
Total playing time*
(including selected track)
To cancel Programme Play
Press PLAY MODE repeatedly until
"PROGRAM" or "SHUFFLE" disappears
from the display.
To Press
Check the CHECK on the remote
programme repeatedly. After the last
track, "CHECK END" appears.
Clear a track CLEAR on the remote in
from the end stop mode.
Clear a specific
CHECK on the remote
track
repeatedly until the number of
the track to be erased lights,
then press CLEAR.
Add a track to
1 Select the disc tray with a
the programme
DISC 1~5 button.
2 Select the track by turning
the jog dial.
3 Press ENTER.
Clear the entire s once in stop mode or twice
programme during playback.
Tips
• The programme you made remains in the system's
memory even after it has been played back. Press
H to play the same programme again.
• If "--.--" appears instead of the total playing time
during programming, this means:
– you have programmed a track number
which exceeds 20
– the total playing time has exceeded 100 minutes.
Note
During programme playback, D.SKIP does not
function as a disc skip button. Pressing D.SKIP
enters programme input mode. If you do not want
to add tracks to the programme, leave alone until
programme input mode is cancelled automatically.