Superior DRL6542TEN Installation And Operation Instructions Manual page 50

Innovative Hearth Products
DRL6500 Linear Direct-Vent Gas Fireplaces
Installing Gas Conversion kits
The gas supply shall be shut OFF prior to disconnecting the electrical power, before proceeding
with the conversion.
Avant d'effecteur la conversion, coupez d'abord l'alimentation en gaz, ensuite, coupez
l'alimentation electrique.
1. TURN OFF THE GAS SUPPLY TO THE FIREPLACE and disconnect power supply at the circuit breaker. Ensure
2. If installed, remove the barrier and bezel.
3. If installed, remove the surround.
4. Remove the glass door (Page 50).
5. Remove the glass media (Page 50).
6. Remove floors if installed.
7. Remove the two (2) screws securing the burner assembly. Remove the burner assembly with the attached
8. Remove the control compartment access door and gasket (Figure 44).
Figure 44 - Removing the Burner and Accessing the Control Compartment
9. Refer to the instructions provided with the SIT regulator conversion kit. Using a Torx T20 driver (with 1/4"
10. Install the new pressure regulator assembly using the supplied screws. Tighten the screws to 25 in. lbs.
11. Install the enclosed identification label to the valve body where it can be easily seen.
50
fireplace is cold.
venturi tube (Figure 44).
Right Burner
Bracket
Control Compartment
Access Panel and Gasket
shank) or slotted screwdriver, remove and discard the two (2) pressure regulator mounting screws, pressure
regulator tower, the diaphragm assembly (if applicable) and the spring. Ensure the rubber gasket installed on the
back of the replacement pressure regulator is properly positioned. Discard all removed components.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
WARNING
AVERTISSEMENT
Remove two screws
to remove burner
assembly.
Burner
Assembly
Venturi
Burner
Orifice
Right Burner Bracket
Operation
900077-00, 07/2015