External Devices & Netcommand® Setup - Mitsubishi WD-52525 Owner's Manual

Connecting External Devices & NetCommand
NetCommand is able to control many current audio and video devices by sending remote control signals from the
TV to each device through IR emitters. Additionally, it is also able to learn the remote control signals used by most
audio video devices not already in the TV's memory. NetCommand can automatically switch the TV and compatible
or learned Audio/Video (A/V) Receivers to the correct input used with each device. It is important that the inputs on
the TV and A/V receiver back panels match the NetCommand setup that is displayed on-screen.
To simplify the installation of NetCommand, there is a step-by-step on-screen NetCommand Setup procedure in this
chapter, which details the type and brands of devices you are connecting to the TV. The NetCommand Setup also
assigns preset TV and A/V receiver inputs for each device. You should connect each device to the TV input (both
audio and video) and to the A/V receiver (audio) as shown in the figure below.
video and stereo
audio cables
TV
The following charts show which preset inputs you should use on the TV and A/V receiver.
Chart 1 shows TV inputs.
Chart 2 shows the A/V receiver inputs used by A/V receiver models already known by NetCommand.
Chart 1
Device Audio and Video Outputs to TV Inputs
Cable for CableCARD™ Service
Antenna/Cable (digital/analog)
Cable box
VCR
Satellite Receiver (DBS)
Camcorder
DVD Player
Mitsubishi 1 Mitsubishi 2
Chart 2
Model Model
M-VR800 & M-VR900 &
M-VR1000 M-VR700
Device Audio Output to AV Receiver Inputs by Name
VCR VCR 1 VCR
Satellite Receiver Aux Cable/DBS
DVD Player
DVD DVD
TV Monitor Output TV
(& Digital Audio)
After using NetCommand Setup, you may go to the NetCommand menu at any time to change the inputs you used
for connecting each device, custom name devices, add devices not included in the presets above or delete devices
no longer used. See Edit NetCommand. See Helpful Hints, at the end of this chapter for additional information on
device setup.
16
Device to be
connected
IR Emitters
stereo and digital audio cables
ANT-1
ANT-1 if primary viewing source,
ANT-2 if secondary viewing source
ANT-2
Input-1
Input-2
Input-3 (on front panel)
Component-1
Bose Denon Integra
Model Model Model
Lifestyle ®28 AVR-2700 DTR-9.1
VCR VCR-1 Video 1
AUX CD Video 3
(built-in) DVDVDP
TV TV TV/DBS Video 4
stereo and/or digital
audio cables
Kenwood Marantz Pioneer 1
Model Model Model
VR-2080 SR8200 VSX-D557
Video 1 VCR1 VCR/Tape VCR 1/DVR
Video 3 DSS CD
DVD Video 4 DVD LD/SAT
Video 4 TV DVD/TV
® Setup
AV
Receiver
Pioneer 2 Rotel Sony Yamaha 1 Yamaha 2
Model Model Model
VSX-49TX RSX-1065 STR-DE825 RV-X2095
Video 2 Video 1
SAT Video 4 TV/DBS
DVD/LD Video 5 TAPE/MD
TV Video 1 DVD/LD
Model Model
RX-V2200
VCR 1 VCR 1
TV/DBS D-TV/LD
CD DVD
DVD/LD CBL/SAT