Netcommand® Controlled Recordings; Netcommand® And Traditional Vcr's; Recording Now; Time-Delayed Recording - Mitsubishi WD-52525 Owner's Manual

NetCommand
Record To Setup
Figure 12
Your TV is able to start and stop recordings
automatically and send the signals from one external
playback device to another external recording device.
It is also able to convert digital channels and IEEE
1394 device signals to analog signals that can be
recorded on NetCommand compatible analog VHS
and S-VHS VCRs.
You cannot record from an analog channel or device
or a VHS or S-VHS VCR to a digital recording device
such as a DVCR or A/V Disc. Also, if you select an
analog channel, you will not be able to record to a
digital device.
You can schedule the recording to take place at a
later time and program the recording duration for a
minimum of 30 minutes and a maximum of 6 hours (in
30 minute increments). The default is 1 hour.
When a digital recording is being made, the TV will
direct the signals to the recording device using the
IEEE 1394 cable. When an analog recording is being
made, the TV will direct signals to the recording using
the monitor audio/video outputs.
During the recording, the TV can be powered Off. If
the TV is powered On, it must be tuned to the source
that is being recorded.
Figure 12. Record to screen
54
® Controlled Recordings

Recording Now

Can be used when viewing Antenna 1 or 2, an IEEE
1394 device, or a non-recording traditional device.
To initiate recording now:
1. Press REC (record) on the TV remote.
2. Press DEVICE on the remote control to move to the
Source Device section.
3. Press ADJUST or
you will record from.
4. Press ENTER to confirm selection and return to the
"Record to" section.
5. In the "Record to" section, review the destination
device (VCR) and duration. Change if necessary.
6. Press REC a second time to initiate recording.

Time-Delayed Recording

To initiate a time-delayed recording:
1. Press REC (record) on the TV remote.
2. Press DEVICE on the remote control to move to the
Source Device section.
3. Press ADJUST , ,
device you will record from.
4. Press ENTER to confirm your Record from
selection and move to the Record to section.
5. Press ADJUST or
device, duration time, start time (press ENTER
after selecting hour, minutes and AM or PM to set
the time) and day. For devices that can select
channels, select the channel.
6. Select Add and press ENTER to add the recording
to the record list. If your selection is successful, a
confirmation message will be displayed. If you pick
overlapping times, day(s), or destination devices,
you will see a message stating there is a conflict.
7. To exit, press HOME on the TV remote after all
recordings have been added.
to select the source device
or to select the source
to select the Record to