V-Chip Lock Menu - Mitsubishi WD-52525 Owner's Manual

V-Chip Lock Menu: Passcode
V-Chip
Select V-Chip Lock to perform the functions listed
below. V-Chip allows you to Block or Allow programs
based upon rating signals sent by the broadcaster.
The TV comes from the factory with the V-Chip Lock
in the Off setting.
You can turn the V-Chip on within the V-Chip Menu or
you can use the V-CHIP button on the remote control
to conveniently turn the V-CHIP on or off.
The factory preset is TV-PG for TV ratings or PG for
movie ratings, allowing only programs rated TV-PG/
PG or lower. You can change the blocking level to
various TV ratings and lettered categories or movie
ratings. After changing channels or devices, there
may be up to a 5 second delay before the V-Chip lock
takes effect.
IMPORTANT
If you forget your four-digit Passcode,
see Appendix A.
Entry
Figures 19 and 20
You will see the screen shown in Figure 21 when you
press V-CHIP on the remote control, the first time
you select the V-Chip Lock menu, or after you have
canceled your passcode. To use the Lock, input a
four-digit passcode with the number buttons on the
remote control, then press ENTER. You can delete
a number and move back one space by pressing
CANCEL. You can exit without inputting a passcode
by pressing MENU or HOME.
After setting a passcode, the V-Chip Lock is active.
The next time you select V-Chip Lock you will see
"...enter your passcode" instead of "...enter a new
passcode".
������ ������ ����
�� �� �� ��� ����� ����� � ��� ���������
��� ��� ������ ������� ��� ����� ������
Figure 19. V-Chip Entry screen
70
� � � �
To view a V-Chip blocked program or to watch the
program during a scheduled lock time, you must
enter your 4-digit passcode or change the channel
to an unlocked program. Once you have entered
the passcode, the V-Chip block or Lock by Time will
remain released until the TV is powered Off and then
On again.
������� �� �������
������ ������ ��� ������� ������� ��� ������ ��
����� ����
�� ����� ��� �������� ����� ���� ���������
��� ��� ������ ������� ��� ����� ������
Figure 20. V-Chip Passcode screen
V-Chip Start Time and V-Chip Stop
Time
Figure 21
Select the times you would like the V-Chip to be active.
By setting the V-Chip Start Time and V-Chip Stop
Time to the same time, the V-Chip will be active 24
hours a day.
Press ADJUST or to slowly select the time,
starting with the hours. Press and hold ADJUST
or to quickly select the hours, press ADJUST
select the minutes.
Figure 21. V-Chip Menu, Start & Stop Time
� � � �
to