Netcommand® Menu; Transport Menu - Mitsubishi WD-52525 Owner's Manual

NetCommand® Menu
NetCommand Menu
Figure 10
Figure 10. NetCommand Menu
NetCommand
Detailed information regarding setting up and editing
the NetCommand menu is found in Chapter 3. The Edit
NetCommand screens allow you to add new devices,
change or edit traditional and IEEE 1394 devices, turn
devices and unused inputs On or Off, delete a single
device or delete the entire setup configuration. If you
choose to delete the entire configuration, or if the
NetCommand setup was cancelled, deleted or not
completed, you can start at the Initial NetCommand
screen. The Review screen shows all devices
connected to the TV, including IEEE 1394 devices.

Transport Menu

Figure 11
Main Picture
Figure 11. Transport Menu
NetCommand uses the Transport menu to control
VCRs, DVDs, IEEE 1394 AV Discs, digital VCRs, and
similar devices. If you choose to turn off this menu
when viewing the devices, the transport buttons
(rewind, play forward, stop, pause and record) on the
TV's remote control will continue to operate these
devices. In the Device Selection menu selecting a VCR
or DVD Player will automatically display the Transport
menu. You can re-display this menu by pressing
DEVICE MENU.
Select Transport menu functions by pressing ADJUST
, , or and then ENTER. For example, to pause
playback, press ADJUST
press ENTER. If a function is not possible, such as record
for a DVD Player, the Transport menu button will be
grayed out.
64
or to move to PAUSE, then
Remote Control Transport Buttons
Transport buttons (rewind,
play forward, stop, pause
and record) on the remote
control are located in the
bottom section of the remote
control.
Default Digital Record Device
If multiple recording devices are available in
NetCommand, this setting allows you to choose the
device to use when recording digital programs. A
digital recording can be made on either a digital or
analog device although the quality will not be as good
if recorded on an analog device. For best playback
quality, record digital programs on a digital recording
device.
If multiple devices were not connected and then
added in the NetCommand setup, this setting will
be unavailable (grayed out). Analog recordings can
only be made on the one analog device connected to
Monitor Out (usually a VCR) and are not affected by
this setting. This feature is most useful when recording
from ChannelView™ (page 53).
Icon Order
Figure 12
The Icon Order screen allows you to arrange the device
icon order on the Device Selection menu to a different
sequence, for ease of selection and operation.
To change the order, press ADJUST
highlight the icon to be moved and then press ENTER.
Press ADJUST , , or
desired position and then press ENTER to select the
icon.
Figure 12. Icon Order Menu
����
�����
���
���������
�������
�������
����
������� ������
����
, , , or to
to move the icon to the