NEC 2400 Integration Manual page 97

Use the following instructions to check or correct the default settings.
1. To access the edit forms used to change the serial data links, press
to access the MCI MAIN MENU.
FUNC
After you press the key, you see the MCI MAIN MENU as shown in the
following example:
NEC
2. Select Utils from the menu by pressing
After you press the key, you see the UTILS menu as shown in the following
example:
UTILS
3. Press on the SID keypad to access the SERIAL menu.
3
After you press the key you see the SERIAL menu as shown in the
following example:
SERIAL
4. Enter the menu item number of the serial data link you need to edit.
When you select MCI or Centrex (SMDI) from the menu, you access four
edit forms. Use the forms to set the serial data to the values your
application requires. For example, press
NOTE:
Both the MCI and Centrex edit forms appear the same, except for
the edit form name. The MCI forms were chosen only as an
example in this document. You can select either serial data link or
both. You also can use the default values, as described earlier in
this section.
5. After you press the key, you see the BAUD RATE edit form as shown in the
following example:
MCI
<- ->1
1-View 2-Utils
4-Setup 5-Logs
2
1-Login 2-Date/Time
1-Centrex
Baud Rate:
Administer Serial Data Links
3-System
on the SID keypad.
3-Serial
2-MCI
on the keypad.
2
1200
Issue 2 December 1995
8-9