Safety Considerations; Factory Assembled Systems - NEC 2400 Integration Manual

Safety Considerations

!
CAUTION:
Electrostatic discharge damages electronic equipment. Do not touch any
electronic component until you properly ground yourself.
To prevent damage to the equipment and yourself, follow these precautions:
Familiarize yourself with the procedures necessary to prevent electrostatic
damage to equipment.
Shut off all power and remove all cables from equipment.
Properly ground a work mat and wrist strap.
Place the equipment on the work mat.
Place the grounded wrist strap on your bare wrist. The wrist strap must
contact your bare skin directly. Do not wear the wrist strap over your
clothes.

Factory Assembled Systems

The factory performs assembly, load, and test (ALT) processes for most of the
INTUITY hardware and software before shipping the system to the site. Use the
information in this chapter to confirm that the system contains the hardware and
software for your configuration.
After checking the installed hardware and software, perform all tasks not
completed during ALT, such as connecting the voice and data lines, setting up
and cabling the peripherals, and installing the switch communications software.
Use one of the following checklists to make sure you complete all necessary
tasks:
INTUITY MAP/5 Installation Checklist, 585-310-147
INTUITY MAP/40 Installation Checklist, 585-310-137
INTUITY MAP/100 Installation Checklist, 585-310-141
Safety Considerations
Issue 2 December 1995
1-3