Connect The Mci Line To The Switch - NEC 2400 Integration Manual

Connect the MCI Line to the Switch

The customer or the customer's switch technician must complete this task. AT&T
does not assume responsibility for any cable connections to the NEAX 2400
switch.
The NEAX 2400 switch communicates with the SID through a Message Center
Interface (MCI) link. To connect the link, the customer must provide a cable to
connect to the MCI digital port and also provide an A25B cable to connect to the
MCI cable. Figure 4-2 shows all of the cables and connections required for the
integration.
Digital
information
link
(MCI link)
Multi-port
serial card
Modular
cable
RS-232
6-25 pin
adapter
Analog
(voice) link
IVC6
Modular
cable
Figure 4-2. NEAX Connections to the INTUITY System
NOTE:
To reduce the chance for data communication errors, do not exceed the
Electronics Industry of America (EIA) RS-232 standard cable length of 50
feet.
Demarcation
Null cable
(shipped
SID
with SID)
RS-232
cable
Connect the MCI Line to the Switch
point
Customer-
NEAX 2400
provided switch
connection
to NEAX
PA-16LCQ
analog port
Issue 2 December 1995
4-3