NEC 2400 Integration Manual page 64

Administering the INTUITY System for the NEAX Integration
Table 6-1.
Field
Data link test
number
Serial port
Baud rate
Comment
6-4
Issue 2 December 1995
Switch Link Administration Screen Entries
Indicates the test number sent to the switch to verify
whether the switch is active.
Setting: A 7- or 10-digit number that is not an in-
service extension number. The number of digits must
agree with the setting for the dialstring size set on the
SID. Refer to Chapter 3, "Switch Integration Planning",
to find the dialstring size.
Indicates which port on the multi-port circuit card in the
INTUITY system is connected to the integration device.
Setting: Press
available ports. Settings are in the format /dev/ttysa x,
where x is a letter a - h representing a port on the
circuit card (from right to left). AT&T recommends that
you use /dev/ttysaa as the serial port.
Indicates the rate at which the SID and the INTUITY
system communicate.
Setting: A baud rate of 1200, 2400, 4800, or 9600.
Press
CHOICES
settings. This setting must agree the BAUD setting on
the SID. AT&T recommends that you use a baud rate
of 2400.
Use the field to enter a comment. Enter a maximum of
30 characters. In your comment, do not use double
quotation marks (") or
Description
(F2) to choose from a menu of
CHOICES
(F2) to choose from a menu of possible
+ backslash (\).
SHIFT