Configure The Settings Relating To Panasonic Alarm Protocol [Notification] - Panasonic WV-SF330 Series Operating Instructions Manual

Note
SW355 SW355 SW352 SW352
SW152 SW152 NP502 NP502
•
Notification E-mail will be sent with the message "The capacity of the SD memory card is full." when
the SD memory card has become full, or "The SD memory card cannot be detected." when mounting
of the SD memory card failed.
13.8 Configure the settings relating to Panasonic
alarm protocol [Notification]
Click the [Notification] tab on the "Alarm" page. (®page 42, page 44)
The settings relating to Panasonic alarm protocol can be configured in this section.
Panasonic alarm protocol notification
[Panasonic alarm protocol]
Select "On" or "Off" to determine whether or not to provide notification by Panasonic alarm protocol according
to the settings for the "Alarm" and "Diag." checkboxes of "Destination of notification" below.
–
When an alarm is detected ("Alarm")
SW355 SW355 SW352 SW352
SW152 SW152 NP502 NP502
–
When a notification of the remaining capacity of the SD memory card has been provided ("Diag.")
–
When the SD memory card has become full ("Diag.")
–
When the SD memory card cannot be recognized ("Diag.")
•
Default: Off
SF346 SF346 SF342 SF342
:
SW115 SW115
SF346 SF346 SF342 SF342 SF335 SF335
:
SW115 SW115
SF335 SF335 SW316L SW316L SW316 SW316
SW316L SW316L SW316 SW316
13 Configure the alarm settings [Alarm]
SP306 SP306 SP305 SP305
SP306 SP306 SP305 SP305 SP302 SP302
Operating Instructions
SP302 SP302 SW155 SW155
SW155 SW155
147