Table of Contents
Advertisement
G. Control Module Heat Shield Installation
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
• Remove black sheet metal plate from manual bag. Bend
(3) tabs approximately 90 degrees on plate to form shield as
shown in Figure 14.3.
Figure 14.3 Heat Shield Bends
Heat & Glo • 6TRSI-AUD, 6TRSILP-AUD • 2078-980 Rev. T • 11/15
• Position heat shield in appliance over control module, being
careful not to pinch any wires. The (2) narrow legs of the heat
shield are facing the rear of the appliance. See Figure 14.4.
Figure 14.4 Heat Shield Placement
65
Hide quick links:
Advertisement
Table of Contents
