General Description; Ordering Information; Board Installation - GE NetworX NX-4 Installation And Startup

Control/communicator

User manual (20 pages)

Table of Contents

NX-4 Control

The NetworX NX-4 represents a new approach to security systems design. Drawing on our experience in the world

market as the largest exporter of USA manufactured controls we have developed the most flexible, durable, and user-

friendly control ever seen in our industry. Featuring sophisticated software which allows up to 8 users to interface with

8 zones, and a host of integrated fire, access, verification, and input/output modules, all reported with the most

comprehensive and fast SIA and Contact ID formats. The NetworX design allows a fully loaded system to be housed in

one single metal enclosure, establishing for the first time, a logical solution and design response to modular systems.

A maximum of 8 keypads and 1 other module (excluding hardwire) can be added to expand the capabilities of the NX-

4 unit. For warranty information, please refer to the current GE Security Product Catalog.

PART #

NX-4-KIT

NX-4 Control, NX-108E LED Keypad, &

16.5V 40VA Transformer

NX-4

NX-4 Control Only

NX-200 **

Zone Doubling Kit (Includes 100 3.74k

and 100 6.98k resistors)

NX-320E

Smart Power Supply and Buss Extender

NX-408E #

8 Zone Wireless Expansion Module

(UL LISTED PART #60-904)

NX-416E #

16 Zone Wireless Expansion Module

(UL LISTED PART #60-904)

NX-448E #

48 Zone Wireless Expansion Module

(UL LISTED PART #60-904)

NX-508E

Eight Output Module

NX-534E ** Two-Way Listen In Module

NX-540E ** "Operator II" Telephone Interface Module

NX-591E ** Cellemetry Interface

** These products have not been tested and approved by Underwriters Laboratories, Inc.

# These wireless devices are only UL listed for residential applications.

IMPORTANT NOTES

The maximum number of zones available is 8 regardless of devices added. Information regarding Zone Doubling

is located on page 7.

The NX-4 control panel will send an "Expander Trouble" once each hour if it senses that no devices have been

enrolled. This report will show "Expander Trouble" - device zero (0).

BOARD INSTALLATION

The metal enclosure should be installed with the door opening from top

to bottom. Refer to the diagram on the right.

Inside the can, there are four slots for board insertion, two on the top

and two on the bottom of the can. These allow the PC board to be

positioned vertically as shown in the diagram. When you slide the

board between the grooves of the slots, make sure the terminal strip is

toward the front for wire connections.

Page 2