GE NetworX NX-4 Installation And Startup page 22

NX-4 Control
DATA
/ Burglary Alarm
0
/ Fire Alarm
1
/ 24 Hour Alarm
2
/ Trouble Alarm
3
/ Tamper Alarm
4
5 Yelping Siren (Burglary)
6 Temporal Siren (Fire)
7 Any Siren
8 Any Bypass
9 AC Fail
10 Low Battery
/ Duress
11
/ Aux 1 Keypad Zone
12
/ Aux 2 Keypad Zone
13
/ Panic Keypad Zone
14
15 Keypad Tamper
/ Autotest
16
17 Alarm Memory
18 Entry
19 Exit
20 Entry or Exit
21 Armed State
22 Disarmed State
23 Ready
24 Not Ready
25 Fire
Notes: When Event 48 is programmed, it is possible to program a user code's authorization to select which output(s)
a particular code will activate. When LED 8 is on for an authorization, then LEDs 1- 2 correspond to that code
activating outputs 1 & 2 respectively. (See programming the LED keypads on page 8.)
˜ Events 49 & 50 require NX-408E, NX-416E or NX-448E wireless receivers to operate.
/ If set to follow condition, these events will be 1 second.
LOCATION 51 - AUTOTEST CONTROL (4 segments, numerical data)
Program a "1" if the interval is to be in hours; Program a "0" if in days. Add a A2" to suppress the
Segment 1:
daily test or a A3" to suppress the hourly test if any report has been sent.
Segment 2: Program the Autotest interval from 1-255 hours/days.
Segment 3: Program the Autotest report hour in 24-hour format (if the interval is in hours, this segment is
ignored).
Segment 4: Program the Autotest report time, number of minutes after the hour.
Page 20
AUXILIARY OUTPUT EVENT SELECTION
EVENT DATA
26 Fire Trouble
27 Chime
/ Expander Trouble
28
29 Dynamic Battery Test Time
30 Open Period
31 Closed Period
32 Listen-In
33 Line Seizure
34 Ground Start
35 Fail To Communicate
36 Reserved
37 Program Mode
38 Download In Process
39 Reserved
40 Short Circuit (Over-current)
41 Box Tamper
42 Siren Tamper
43 Any Open
44 Any Short
45 Any Fault (Open/ Short on Non-Fire Zone)
/ Any Alarm
46
47 Beeping Keypad
/ Code Entry (See note below)
48
49 ˜ / Key FOB Function 1
50 ˜ / Key FOB Function 2
EVENT