GE NetworX NX-4 Installation And Startup page 31

LOC PG
39 18 KEYPAD SOUNDER CONTROL
Segment #1 (Circle numbers to program)
1 Reserved.
2 Reserved.
3 Keypad sounds upon AC Power Failure.
4 Keypad sounds upon Low Battery Detection.
5 Keypad sounds during Cross Zone Trip Time.
6 Keypad sounds for Tamper Alarm.
7 Reserved.
8 Keypad sounds for expander trouble (required for UL).
40 18 SYSTEM TIMERS
Segment #1 Dynamic Battery Test duration (0-255 min.)
Segment #2 AC Failure report delay (0-255 minutes)
Segment #3 Power Up Delay (0-60 seconds)
Segment #4 Siren Time (1-255 minutes)
Segment #5 Reserved
Segment #6 Cross Zone Time (0-255 minutes)
Segment #7 Chime Time in 50 mS increments (0-255)
Segment #8 Dialer delay (15-255 seconds)
Segment #9
Segment #10 Listen-In Time (0-255 seconds)
41 19 USER CODE REQUIREMENTS
Segment #1 (Circle numbers to program)
1 Enables six-digit code option. All arm/disarm/Go To Program codes require six digits
2 Requires valid user code entry for [r]-[9]-[8] and [r]-[9]-[9] functions to work.
3 Enables Auto Cancel/Abort.
4 Enables Walk Test mode.
5-8 Reserved.
42 19 GO TO PROGRAM CODE
43 19 GO TO PROGRAM CODE AND AUTHORIZATION
Segment #1 (Circle numbers to program)
1 Reserved.
2 Enables "Go To Program Code" as an arm only code.
3 Enables "Go To Program Code" as an arm only after closing.
4 Enables "Go To Program Code" as a master arm/disarm code (can change user codes)
5 Enables "Go To Program Code" as an arm/disarm code.
6 Enables "Go To Program Code" to bypass zones.
7 Enables "Go To Program Code" opening and closing reports.
8 Reserved.
44 19 DURESS CODE
46 19 AUXILIARY OUTPUTS 1 & 2 SPECIAL TIMING
Segments
Auxiliary output timed in minutes.
Auxiliary output to latch.
Auxiliary output to stop timing upon user code entry.
Auxiliary output to activate only between closing and opening time.
Auxiliary output to activate only between opening and closing time.
Invert auxiliary output (0 volts going to 12 volts when activated).
Reserved
Reserved
DESCRIPTION
Fire Alarm Verification Time (120-255 sec.)
NX-4 Control
DEFAULT
0
5
60
8
0
5
3
30
0
0
9-7-1-3-0-0
15-15-15-15-15-15
1
1
2
3
4
5
6
7
8
DATA
_
_
_
_
_
_
_
_
_
_
_ _ _ _ _ _
_ _ _ _ _ _
2
1
2
3
4
5
6
7
8
Page 29