Headset Instructions - Mitel 8620 User Manual

Getting Started

Headset Instructions

When using a headset, press
If you have both a headset and a handset connected to your IP phone and you are using the
headset, you can quickly transfer audio to the handset by lifting the handset from the cradle.
Press
cradle.
NOTES
To connect and activate the headset:
1. Insert the headset jack into the Headset port located on the back of the IP phone. See
2. Dial 317 to turn the headset on. HEADSET MODE ON appears.
To turn off Headset Mode and activate the handset and speakerphone:
Page 8
(Speaker) to connect to or disconnect from calls.
(Speaker) to transfer the call back to the headset before replacing the handset in the
The headset must be hearing aid compatible (HAC).
If your headset has a power-saver mode, make sure the system administrator has
enabled the "Headset Connect Tone" feature. If this is not enabled, you may miss
the first few seconds of an incoming call.
"Phone Signals" on page 7.
Dial 317. HEADSET MODE OFF appears. The handset or speakerphone is now
activated.
Mitel ® 8620/8622 IP Phone User Guide – Issue 14, June 2010