Factory Default; Backup Setting Data; Restore Setting; Initialize Tab - Sony ipela SNC-RH124 User Manual

SNC-RH124, SNC-RH164
You can change the signal setting for NTSC or PAL.
Select either of NTSC + IP or PAL + IP. No analog
image outputs when IP only is selected.
Switching NTSC/PAL prompts "This system will be
rebooted. Are you sure?". Click OK to restart the
camera and change the settings.
Line lock (SNC-RS46N/P, SNC-RS44N/P,
SNC-RS86N/P, SNC-RS84N/P only)
Select whether to generate the synchronization signals
for recording images in the camera or synchronize the
synchronization signals with the power frequency.
Internal: Generates synchronization signals in the
camera.
External: Synchronizes synchronization signals with
the power frequency.
Phase adjustment (SNC-RS46N/P, SNC-RS44N/
P, SNC-RS86N/P, SNC-RS84N/P only)
Set the phase adjustment by line for synchronization
signals which synchronized with the power frequency.
SNC-RS46N , RS44N , RS86N , RS84N: 0 to 524
SNC-RS46P , RS44P , RS86P , RS84P: 0 to 624
Note
Phase adjustment is available when the Line lock setting
is External.
OK/Cancel
See "Buttons common to every menu" on page 31.

Initialize Tab

Reboot
Used when rebooting the system.
Click Reboot, and the message "This System will be
rebooted. Are you sure?" appears. Click OK to reboot
the camera. It takes about two minutes to restart.

Factory default

Resets the camera to the factory settings.
Restore network setting
When this item is checked, only the current network
settings will be retained after reset.
Click Factory default, and the message "Setup data will
be initialized. Are you sure?" appears. When you click
OK, the network indicator on the camera starts to blink.
After adjustments of the default settings have finished,
the camera reboots automatically. Do not turn off the
camera until the camera reboots.
Tip
The camera can also be reset to the factory settings by
turning on the power of this unit while pressing the reset
button on the camera. For details, see the supplied
Installation Manual.

Backup setting data

Saves the setting data of the camera in a file.
Click Save, and follow the instructions on the Web
browser to specify the folder and save the setting data of
the camera.
The file name preset at the factory is "snc-rh124.cfg" for
SNC-RH124.

Restore setting

Loads the stored setting data of the camera.
Click Browse and select the file in which the setting data
is stored. Click OK, and the camera is adjusted
according to the loaded data, and restarted.
Restore preset position, privacy masking and
shadow tour settings
If you select this, the stored setting data of the camera,
the preset position data privacy masking data and
shadow tour setting data are loaded.
Notes
• With Restore setting, some items in the Network
menu (page 47) cannot be restored.
• When Restore preset position, privacy masking
settings or Shadow tour setting is selected\loading of
setting data may take some time.
• The following items cannot be stored or restored with
Backup setting data or Restore setting.
– audio files uploaded using SNC audio upload tool
– a panorama image recorded in the camera using
Panorama Creator of SNC toolbox
– a homepage created using Custom Homepage of
SNC toolbox
– a client certificate and CA certificate to be used in
the 802.1X authentication function
– Thumbnail
Configuring the System — System Menu
37