Wireless Tab - Setting Of Wireless Connection; Host Name; Domain Suffix; Http Port Number - Sony ipela SNC-RH124 User Manual

Host name

Type the host name of the camera to be transmitted to the
DHCP server. This setting is valid only when Obtain an
IP address automatically (DHCP) is selected in the
Network tab.

Domain suffix

Type the domain suffix of the camera to be transmitted
to the DHCP server. This setting is valid only when
Obtain an IP address automatically (DHCP) is
selected in the Network tab.
Note
The domain suffix is sent to the DHCP server as FQDN
(Fully Qualified Domain Name) information when Host
name is set.

HTTP port number

Normally select 80. If you want to use a port number
other than 80, select the text box and type a port number
between 1024 and 65535.
Note
When you have set the HTTP port number to a number
other than 80 in the Network menu or in SNC toolbox,
access the camera again by typing the IP address of the
camera on your Web browser as follows:
Example: Setting port number 8000 when IP address is
192.168.0.100

IPv6 setting

Configure the IPv6 network settings.
IPv6 can be used simultaneously with IPv4.
Only IPv6-specific details are explained here. For
common details, see "IPv4 setting" on page 47.
On/Off
To use IPv6, select On.
Prefix
Enter the Prefix value. (0 to 128)
IPv6 MTU
Enter the MTU value for IPv6. (1280 -1500)
The value must not exceed the MTU value for the
Ethernet port.
OK/Cancel
See "Buttons common to every menu" on page 31.
48
Configuring the Network — Network Menu
Wireless Tab — Setting of wireless
connection
Insert the specified wireless card into the CF card slot of
the camera, and set the items for connecting to the
wireless network.
Before setting, read the operation manual and
installation manual supplied with the wireless card
together with this guide.
Verified wireless cards
• Sony Wireless Card SNCA-CFW5* sold separately.
* SNCA-CFW5 is not available in some countries and
areas. For details, contact your authorized Sony
dealer.
Notes
• Before removing the wireless card from the camera,
turn off the power of the camera.
• The throughput of data transmission/reception via the
network cable may decrease when the wireless card is
in use.
• If the camera is powered by PoE, it will not start when
the CF card is inserted. (SNC-RH124, SNC-RS46N/P,
SNC-RS44N/P only)

MAC address

Displays the MAC address of the wireless card inserted
in to the CF card slot.
If a wireless card is not inserted, "00:00:00:00:00:00"
will be displayed.