Sony ipela SNC-RH124 User Manual page 92

Preset
Notes
• Camera control can be used when the mode is
"Current position" mode.
• Detection settings and VMF settings should be saved
independently when the and Current position and
Preset is selected.
Detection settings
Detection area
Specify the effective scope of motion detection.
Configuring the detection area
The following procedure is used to configure the motion
detection area:
1
Use the following buttons to specify the active
area(s) and inactive area(s).
Adding an active area
Clicking Adding an active area will add an active
area window in the center of the screen.
When you place the cursor on the area, the cursor
changes to a crossed arrow, which you can drag to
move the area.
When you place the cursor on the vertex of the area,
the cursor changes to n, which you can drag to
move the vertex.
92
Setting the Sensor input/Camera tampering detection/Motion detection/Audio detection — Event detection menu
Adding an inactive area
Clicking Adding an inactive area will add an
inactive area window in the center of the screen.
When you place the cursor on the area, the cursor
changes to a crossed arrow, which you can drag to
move the area.
When you place the cursor on the vertex of the area,
the cursor changes to n, which you can drag to
move the vertex.
Deleting a region
Clicking this button will change the cursor to a
button. While the cursor is a button, click on a part
of the area to delete that area.
After the deletion, the cursor will return to its
original form. To exit this operation, click this
button again.
It is the same function as the button displayed under
VMF settings.
Adding a vertex
Clicking Adding a vertex will change the cursor to
a button. In that state, when you click on a part of
the side of the area, a vertex is added to that point.
After the addition, the cursor will return its original
form. To exit this operation, click this button again.
It is the same function as the button displayed in
VMF settings.
Deleting a vertex
Clicking Deleting a vertex will change the cursor
to a button. In that state, when you click on a part of
the vertex of the area, the vertex added to that point
is deleted. After the deletion, the cursor will return
its original form. To exit this operation, click this
button again.
It is the same function as the button displayed in
VMF settings.
Note
The vertex can be moved in an outward direction
but cannot be moved toward the inside of an area.
Detection sensitivity
Set the sensitivity of motion detection.
A value from 1 to 100 can be specified.
The values of the slide bar and spin button are
synchronized.