Initialize Tab; Backup Setting Data; Restore Setting; Factory Default - Sony Ipela SNC-EP520 User Manual

• If the PSE with which you will use this unit cannot
supply sufficient power and you set the HPoE LLDP
function to Off, the unit may not operate correctly.
• The HPoE LLDP function may be slow to start if the
LLDP function is set to ON and PSE is not used for
some LLDP functions.
Eflip
You can display flip vertical images on the computer.
Select Off when you hang the camera from a ceiling.
Select On when you install the camera on a rack, etc.
Note
Panorama images, thumbnails set in the Preset Setting
menu, privacy mask positions and motion detection
areas, etc., will not be inverted, even if the On/Off
setting of the inverted image is switched. To invert the
image, make the setting again.
OK/Cancel
See "Buttons common to every menu" on page 35.

Initialize Tab

Display sample: SNC-ER580
Reboot
Used when rebooting the system.
Click Reboot, and the message "This System will be
rebooted. Are you sure?" appears. Click OK to reboot
the camera. It takes about two minutes to restart.

Factory default

Resets the camera to the factory settings.
Retain current network settings
When this item is checked, only the current network
settings will be retained after reset.
Click Factory default, and the message "Setup data will
be initialized. Are you sure?" appears. When you click
OK, the network indicator on the camera starts to blink.
After adjustments of the default settings have finished,
the camera reboots automatically. Do not turn off the
camera until the camera reboots.
Tip
The camera can also be reset to the factory settings by
turning on the power of this unit while pressing the reset
button on the camera. For details, see the supplied
Installation Manual.

Backup setting data

Saves the setting data of the camera in a file.
Click Save, and follow the instructions on the Web
browser to specify the folder and save the setting data of
the camera.
The file name preset at the factory is "snc-ep520.cfg" for
SNC-EP520.

Restore setting

Loads the stored setting data of the camera.
Click Browse and select the file in which the setting data
is stored. Click OK, and the camera is adjusted
according to the loaded data, and restarted.
Restore preset position and privacy masking
settings
If you select this, the stored setting data of the camera,
the preset position data and privacy masking data are
loaded.
Notes
• With Restore setting, some items in the Network
menu (page 51) cannot be restored.
• When Restore preset position and privacy masking
settings is selected, loading of setting data may take
some time.
• The following items cannot be stored or restored with
Backup setting data or Restore setting.
– audio files uploaded using SNC audio upload tool
– a panorama image recorded in the camera using
Panorama Creator of SNC toolbox
– a homepage created using Custom Homepage of
SNC toolbox
– a client certificate and CA certificate to be used in
the 802.1X authentication function
– Thumbnail
– Header logo
– Camera ID image
Configuring the System — System Menu
41