Trigger Size; Trigger Speed; Stretch Bar - Sony ipela SNC-RH124 User Manual

Trigger size

Specify the minimum trigger size and maximum trigger
size of the object. To specify the size, you can either
enter values or drag the vertexes of the area.
The size of an object is measured in pixels.
• When you place the cursor on the area, the cursor
changes to a crossed arrow, which you can drag to
move the minimum trigger size area and maximum
trigger size area.
• Placing the cursor on the vertex of the minimum
trigger size area or maximum trigger size area will
change the cursor to n, then you can drag the vertex
to change the inspection size.
Tip
The minimum and maximum detection sizes configured
in the VMD setting are displayed, but the size of the area
cannot be modified from here.
96
Setting the Sensor input/Camera tampering detection/Motion detection/Audio detection — Event detection menu

Trigger speed

Specify the range of the speed of object to inspect by
determining Min. speed and Max. speed.
• Min. speed and Max. speed can be specified within a
scale of 100.
• The blue marker for minimum speed cannot be set to
the right of the red marker for maximum speed.
• The squares indicating Min. speed and Max. speed
move on the right and left sides of the preview screen.
Note
The set value is only valid under the conditions of
Passing, Appearance or Disappearance.
Full-screen display button
Click to display the ActiveX area in full screen.
Clicking again will show the normal display.

Stretch bar

Click to hide the menu list on the left and enlarge the
preview screen.
Clicking again will show the menu list as it was before.
OK/Cancel
Click OK to finalize any changes made to the settings
and send them to the camera.
If you click Cancel, changes made to the settings will be
discarded and the screen will be reloaded with the
current camera settings.