Initialize Tab; Factory Default - Sony Ipela SNC-ER585 User Manual

Select ON in the case of IEEE802.3at compatible power
adjustment by PSE (Power Sourcing Equipment).
Notes
• Before setting, check the specifications, power level
and settings of the PSE you are going to connect.
• If the PSE with which you will use this unit cannot
supply sufficient power and you set the HPoE LLDP
function to Off, the unit may not operate correctly.
• The HPoE LLDP function may be slow to start if the
LLDP function is set to ON and PSE is not used for
some LLDP functions.
Eflip
You can display flip vertical images on the computer.
Select Off when you hang the camera from a ceiling.
Select On when you install the camera on a rack, etc.
Note
Panorama images, thumbnails set in the Preset Setting
menu, privacy mask positions and motion detection
areas, etc., will not be inverted, even if the On/Off
setting of the inverted image is switched. To invert the
image, make the setting again.
Video out (SNC-ZP550/ZR550)
Set the video output from the BNC cable connected to
the SLOC port. When outputting video images, select
On.
Note
• The format for video output signals varies depending
on the Camera operating mode setting. In Camera
operating mode, 30 fps is for NTSC and 25 fps is for
PAL.
• When Video out is set to On, the motion detection
function and Image 2 of Video codec will not be
available.
Stabilizer (SNC-EP520/EP521/ER520/
ER521/ER585/ER585H)
Set Stabilizer. When you select On, the camera image
vibration will be reduced on the place where this unit is
installed with vibration.
Note
• When Stabilizer is set to On, the shooting angle of
view will be narrowed by 20%.
Using preset or cropping functions (SNC-ER585/
ER585H) will also narrow the shooting angle of view.
• If Stabilizer is set to On, the compensation will not be
effective depending on vibration.
• It will take some time before the effect of the
compensation appears after operating the camera's
pan, tilt or zoom functions.
• Since the SNC-ER585/ER585H models integrate the
rolling shutter and CMOS sensor, focal-plane shutter
effects may occur when using the stabilizer function.
OK/Cancel
See "Buttons common to every menu" on page 35.

Initialize Tab

Display sample: SNC-ER580
Reboot
Used when rebooting the system.
Click Reboot, and the message "This System will be
rebooted. Are you sure?" appears. Click OK to reboot
the camera. It takes about two minutes to restart.

Factory default

Resets the camera to the factory settings.
Retain current network settings
When this item is checked, only the current network
settings will be retained after reset.
Click Factory default, and the message "Setup data will
be initialized. Are you sure?" appears. When you click
OK, the network indicator on the camera starts to blink.
After adjustments of the default settings have finished,
the camera reboots automatically. Do not turn off the
camera until the camera reboots.
Tip
The camera can also be reset to the factory settings by
turning on the power of this unit while pressing the reset
Configuring the System — System Menu
41