How To Enter Initial Settings - Furuno FR-8045 Installation Manual

3. EQUIPMENT SETTINGS
3.3

How to Enter Initial Settings

After you complete setting the radar purpose, enter the Initial Settings as follows:
1. On the main menu, press
ARPA
AIS
GPS
System
Initial
Tests
Sector Blanks
Units
Installation
Factory
Use this menu when installing on site
ARPA
AIS
GPS
System
Initial
Tests
Sector Blanks
Units
Installation
Factory
Restoring the default settings
Set the [Sector Blank] to [Off] in order to
execute [Auto Installation Setup] in the
[Installation] menu.
2. Press the ENTER key. The [Installation] menu becomes active and the cursor
moves to the right-hand column.
3. Press
4. Press the ENTER key to show the settings window.
5. Press
6. Press the ENTER key to set the option.
7. Press the MENU key to close the main menu.
Menu
Input Source
ARPA QV Select
Demo Mode
Antenna Rotation
Antenna Height
Near STC Level
A/C Auto Adjust
Heading Adjust
Timing Adjust
[ENTER]: Enter
[MENU]: Exit
Page 2 (Displayed when scrolled down)
Menu
MBS Adjust
Video Init Adjust
ARPA Adjust SP
ARPA Adjust MP
ARPA Adjust LP
Auto Install Setup
Total On Time
Total TX Time
Memory Clear
[ENTER]: Enter
[MENU]: Exit
or to select an item from the [Installation] menu.
or to select an option.
or to select [Installation].
Page 1
Installation
: Master
: Off
: Off
: Rotate
: 15m
: 2
: 0
: 0.0°
: 0.00 NM
[CANCEL/HL OFF]: Back
[CANCEL/HL OFF]: Back
27