Installation Procedure - Furuno FR-8045 Installation Manual

1.2.1

Installation procedure

Refer to the outline drawing at the back of this manual for the dimensions. Make five
holes in the platform. Four holes to fasten the antenna unit and one hole for the signal
cable.
How to fasten the radiator to the chassis
See the packing list at the back of this manual for the installation materials.
1. Remove the radiator cap from the radiator bracket.
2. Apply marine sealant to the surface of the antenna radiator and the radiator brack-
et. See the figure shown below for the location.
3. Apply the marine sealant to the threads in the four holes on the antenna radiator.
4. Apply the grease to the O-ring and set the O-ring to the radiator bracket.
5. Set the antenna radiator on the radiator bracket.
6. Apply the marine sealant to the radiator bolts (4 pieces). Fasten the antenna radi-
ator to the radiator bracket with the radiator bolts, flat washers and spring wash-
ers.
Radiator bracket
Antenna
radiator
O-ring
Flat washer
Spring washer
Hex head bolt
(M8×30)
1. HOW TO INSTALL THE SYSTEM
RADIATOR BRACKET
(top view)
10mm
Coat hatched area with
marine sealant.
Apply marine sealant
to threaded holes
Apply marine sealant
to bolts.
6