Furuno FR-8045 Installation Manual page 23

b) Run the signal cable as shown below.
c) Fix the signal cable with cable clamp as shown below.
Cable clamp
11. Release the stay and close the cover. Loosely fasten the antenna bolts; you will
have to make some adjustments inside after completion of wiring.
Note: When you close the cover, set the gaskets to the grooves in the bottom chassis,
then tighten the bolts.
RTB board cover
Bottom
Chassis
Groove
Gasket
Antenna Bolt
Torque : 9.8 ±0.1 Nm
18
1. HOW TO INSTALL THE SYSTEM
Top view