Lexus ES350 Manual page 819

818
7-2. Steps to take in an emergency
Connect a positive jumper cable clamp to the positive (+) battery
1
terminal on your vehicle.
Connect the clamp on the other end of the positive cable to the pos-
2
itive (+) battery terminal on the second vehicle.
Connect a negative cable clamp to the negative (-) battery terminal
3
on the second vehicle.
Connect the clamp at the other end of the negative cable to a solid,
4
stationary, unpainted metallic point away from the 12-volt battery
and any moving parts, as shown in the illustration.
Start the engine of the second vehicle. Increase the engine speed
3
slightly and maintain at that level for approximately 5 minutes to
recharge the 12-volt battery of your vehicle.
Open and close any of the doors of your vehicle with the "POWER"
4
switch off.
Maintain the engine speed of the second vehicle and start the hybrid
5
system of your vehicle by turning the "POWER" switch to ON mode.
Make sure the "READY" indicator comes on. If the indicator does not
6
come on, contact your Lexus dealer.
Once the hybrid system has started, remove the jumper cables in the
7
exact reverse order from which they were connected.
Once the hybrid system starts, have the vehicle inspected at your Lexus
dealer as soon as possible.
ES350_300h_OM_OM33A60U_(U)