Engineering Mode Overview - Horizon Fitness 622T Service Manual

CHAPTER 2: ENGINEERING MODE
2.2 Engineering Mode – Overview
MODE FUNCTION
ENG 0 Display Test
ENG 1 Hardware Test
ENG 2 Auto Calibration
ENG 3 Switch Function
ENG 4 Information
Software Version
SECOND
LEVEL
ENG 8
* Demo off – The console will display Figure A after the removal of the safety key.
* Demo on – 60 seconds after the removal of the safety key, the console will enter into DEMO ON MODE.
The LED and LCD will display in turns (Figure B).
FIGURE A
Start Key – LCD/LED on
Stop Key – LCD/LED off
Any Other Key - Will show on the display window.
Hold the STOP key for 3 seconds to return to the Engineering Menu.
Motor & Incline Motor Test. Press START then SPEED UP or DOWN to
test the speed. Press INCLINE UP or DOWN to test the incline.
Auto calibrates the speed. The unit will return to normal operation if the
auto calibration passes.
Use the INCLINE or SPEED UP and DOWN keys to switch DEMO
MODE off or on (Demo on = 1 & Demo off = 0 in the TIME window).
Use the START key to select unit (1 = KM & 0 = Mile in the DISTANCE
window).
Accumulated Time and Distance
Press and hold the START key for 5 seconds to clear all data.
Unit of Time is Hour.
Unit of Distance is KM or Mile based on your setting in ENG3.
To Get to ENG 8 - Enter into ENG 3, the press and hold the SPEED UP
and INCLINE DOWN keys at the same time for 3-5 seconds.
Press ENTER at P0 - Software version.
Press ENTER at P1 - Select speed up rate (normal or quick).
Press ENTER at P3 - Hold the START key to clear all data.
DESCRIPTION
FIGURE B
5