Engineering Mode (Inc. Hardware Test, Auto-Calibration, Roller Values, Etc) - Horizon Fitness 1.1T Service Manual

Engineering Mode
Entering Engineering Mode
1.1T
Power on the treadmill and have the safety key in position on the console. Press and hold the elevation
"+" and speed "-" for about 5 seconds to enter the Engineering Mode Menu. The console should beep
three times and Eng 0 should be displayed once in the Engineering Mode Menu.
2.1T, 3.1T, 4.1T, 5.1T
Power on the treadmill and have the safety key in position on the console. Press and hold the elevation
"∧" and speed "∨ " for about 5 seconds to enter the Engineering Mode Menu. The console should beep
three times and Eng 0 should be displayed once in the Engineering Mode Menu
Important Note: For all Engineering modes press and hold
"Stop" to exit.
25