Engineering Mode Overview - Horizon Fitness T303 Service Manual

CHAPTER 2: ENGINEERING MODE
2.2 Engineering Mode – Overview
MODE FUNCTION
ENG 0 Display Test
ENG 1 Hardware Test
ENG 2 Auto Calibration
ENG 3 Switch Function
ENG 4 Information
Software Version
SECOND
LEVEL
ENG 8
*Demo Mode – The console will display Figure A after the removal of the safety key; Demo On – 60
seconds after the removal of the safety key, the console will enter into DEMO ON MODE. The LED
and LCD will display in turns (Figure B).
FIGURE A
Start Key – LCD/LED on
Stop Key – LCD/LED off
Any Other Key - Will show on the display window.
Hold the STOP key for 3 seconds to return to the Engineering Menu.
Motor & Incline Motor Test. Press the START key to get the belt moving
and the SPEED UP or DOWN key to adjust the speed. Press the
INCLINE UP or DOWN keys to test the incline.
Auto calibrates is not used on this model. Will scroll "No Function".
Use the START key to select unit (MI = Miles or KM = Kilometers).
Accumulated Time and Distance
Press and hold the START key for 5 seconds to clear all data.
Unit of Time is Hour.
Unit of Distance is KM or Mile based on your setting in ENG3.
To Get to ENG 8 - Enter into ENG 3, the press and hold the SPEED
DOWN and INCLINE UP keys at the same time for 3-5 seconds.
NOTE: ENG8 contains factory settings and should not be accessed by
the customer unless requested by Horizon Customer Technical
Support.
Press ENTER at P0 – Software version.
Press ENTER at P1 – Select speed up rate (normal or quick).
Press ENTER at P3 - Hold the START key to clear all data.
Press ENTER at P4 – Burn Time on the console.
DESCRIPTION
FIGURE B
5