Table of Contents
Advertisement
CLEARANCES TO COMBUSTIBLES
Minimum Clearances to Combustibles
Minimum clearances include any projections such as shelves, window
sills, mantels, spacers/standoffs or surfaces to combustible construction
etc. above the appliance. Paint or lacquer used to finish the mantel
must be heat resistant in order to avoid discoloration.
The letters in Figure 5 (A through E) show minimum clearances required
from the appliance to combustibles and the minimum projection of the
hearth extension.
Insert Leveling
At each front and rear corner of the insert is an adjustable leg provided
to level the insert should the hearth of the fireplace be uneven. To adjust
the legs, loosen the two 5/32" allen head screws, move the leg to the
desired height and then tighten the screws. Repeat these steps for each
adjusting leg.
Facing and Mantel Clearances
See Figure 4
MINIMUM CLEARANCES TO COMBUSTIBLES
A = Top Facing to Bottom of Appliance ........................ 31-1/2" (800mm)
B = Side Facing or Side Wall to Center of Glass ......... 25-1/2" (648mm)
C = 10-1/2" (267mm) Mantel to Bottom of Appliance . 39" (991mm)
HEARTH PROTECTION
D = Vertical Distance from base of appliance
to Hearth Extension ..........................................
E = Minimum Horizontal Distance
from Front of Appliance ......................................
Figure 5 - Clearances
14
1-1/2"
38mm
Figure 4
..........
DRI3030TENC
0"
2"
4"
(0mm)
(51mm) (102mm)
13"
10"
0"
(330mm) (254mm) (0mm)
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
3"/76mm
3"/76mm
3"/76mm
39"
33-1/2"
991mm
851mm
31-1/2"
36-1/2"
800mm
927mm
MINIMUM CLEARANCES
Front View
MANTEL
MANTEL
FACING
TRIM
A
Left
C L
Side
E
Hearth Protection
NOTE: Hearth protection to be min.
3/8" (10mm) thick non-combustible
or equivalent, with a k factor of .84.
DRI3030TENC
Facing and Mantel
Side View
B
C
Right
Side
D
Advertisement
Table of Contents
