Perkins Customer Assistance; Checking Generator Brushes - Miller Electric Big Blue 400 PX Owner's Manual

8-3. Perkins Customer Assistance

Service
When a problem arises concerning the op-
eration or service of the engine, the prob-
lem will normally be managed by the dealer
in your area.
Your satisfaction is a primary concern to
Perkins and to Perkins dealers. If you have

8-4. Checking Generator Brushes

a problem that has not been handled to your
complete satisfaction, follow these steps:
1 Discuss your problem with a local
dealer or distributor.
2 If your problem cannot be resolved at
the dealer or distributor level without
additional assistance, contact the
Perkins Technical Support Center
through the Perkins website.
5/16 in. (8 mm)
Minimum Length
9/16 in. (14.3 mm)
Replace
Damaged Brushes
Please follow the above steps in sequence
if a problem arises.
Website Address
www.Perkins.com
!
Stop engine and let cool.
1 Generator Brush With Spring
Mark and disconnect leads at brush hold-
er cap. Remove brushes.
Replace brushes if damaged or if brush
material is at or near minimum length.
New Length
1
Ref 222 875 / S−0233−A
OM-223 037 Page 35