Supermicro X10QBL-CT User Manual page 92

X10QBL-CT/X10QBL User's Manual
*If the item above "Configure SATA as" is set to RAID, the following items
will display:
SATA RAID Option ROM Type
Use this item to select the device type for onboard SATA RAID Option ROM for
system boot. The options are EFI and Legacy.
Serial ATA Port 0~ Port 5
This item displays the information detected on the installed SATA drives on the
particular SATA port.
•
Display of drive number and capacity as detected by the BIOS
•
Software Preserve Support
Port 0~ Port 5
Select Enabled to enable a SATA port specified by the user. The options are
Disabled and Enabled.
Hot Plug
This feature designates this port for hot plugging. Set this item to Enabled for
hot-plugging support, which will allow the user to replace a SATA drive without
shutting down the system. The options are Enabled and Disabled.
Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE-
SET initialization to the device. The options are Enabled and Disabled.
PCIe/PCI/PnP Configuration
PERR# Generation
Select Enabled to allow a PCI/PCI-E device to generate a PCI/PCI-E Parity-Error
(PERR) number for a PCI Bus Signal Error Event. The options are Enabled and
Disabled.
SERR# Generation
Select Enabled to allow a PCI/PCI-E device to generate a System-Error (SERR)
number for a PCI Bus Signal Error Event. The options are Enabled and Disabled.
PCI AER (Advanced Error-Reporting) Support
Select Enabled to support Advanced Error-Reporting for onboard PCI devices. The
options are Disabled and Enabled.
4-22