Processor And Heatsink Installation; Installing The E7-4800 V2 Series Processor - Supermicro X10QBL-CT User Manual

2-4

Processor and Heatsink Installation

Warning: When handling the processor package, avoid placing direct pressure on the
label area. Also, improper CPU installation or socket/pin misalignment can cause seri-
ous damage to the CPU or the motherboard and may result in RMA repairs. Be sure
to read and follow all instructions thoroughly before installing your CPU and heatsink.
Notes:
Always connect the power cord last, and always remove it before adding,
removing or changing any hardware components. Make sure that you in-
stall the processor into the CPU socket before you install the CPU heatsink.
If you buy a CPU separately, make sure that you use an Intel-certified
multi-directional heatsink only.
Make sure to install the motherboard into the chassis before you install
the CPU heatsink.
When receiving a motherboard without a processor pre-installed, make
sure that the plastic CPU socket cap is in place, and none of the socket
pins are bent; otherwise, contact your retailer immediately.
Refer to the Supermicro website for updates on CPU support.

Installing the E7-4800 v2 Series Processor

1. There are two load levers on the processor socket. To open the socket lever,
first press and release the load lever labeled 'Open 1st'.
1
Note: All graphics, drawings and pictures shown in this manual are for il-
lustration only. The components that came with your machine may or may
not look exactly the same as those shown in this manual.
2
Press down
on Load Lever
labeled 'Open 1st'.
2-7
Chapter 2: Installation