Supermicro X10QBL-CT User Manual page 13

Jumper Description
JBT1 Clear CMOS
JI C1/JI C2 SMB to PCI-E slots
2 2
JPB1 BMC Enable
JPG1 VGA Enable
JPL1 GLAN1/GLAN2 Enable (X10QBL)
JPTG1 10G-LAN1/ 10G-LAN2 Enable (X10QBL-CT)
JPT1 Trusted-Platform Module (TPM) Enable
JPME2 Manufacture Mode (ME) Select
JPS1 SAS Enable (For X10QBL-CT)
JWD1 Watch-Dog Timer Enable
Connectors
BT2 (Battery)
COM1/COM2
FAN1-FAN10
I-SATA0-5
JD1
JF1
JIPMB1
JL1
JPI C1
2
JPSAS1 (for X10QBL-CT) 2-pin power connector for SAS HDD status support
JPWR1
JPWR2/3/4/5
LAN1/2 (for X10QBL)
LAN1/2 (for X10QBL-CT)
IPMI_LAN
L-SAS0-3, L-SAS4-7 (for
X10QBL-CT)
JSD1/JSD2
X10QBL(-CT) Jumpers
X10QBL(-CT) Connectors
Description
Onboard CMOS Battery (See Chpt. 3 for used battery
disposal.)
Back panel COM port 1/Serial port 2 header
CPU/System fan headers
Intel SATA 3.0/2.0 ports 0-5 (I-SATA 3.0 ports 0/1, I-SA-
TA 2.0 ports 2-5) (supported by Intel PCH)
Speaker/Power LED header
Front Panel Control header
4-pin external BMC I
Chassis intrusion header
Power System Management Bus (SMB) header
24-pin power connection header
8-pin power connectors
Gigabit Ethernet LAN ports 1/2 (supported by Intel
i350 LAN controller)
10G-LAN (TLAN) ports 1/2 (supported by Intel X540
LAN controller)
Gigabit IPMI-dedicated LAN on the I/O back panel
(supported by the BMC for IPMI use)
SAS ports 0-3, 4-7 (supported by LSI 3008 SAS con-
troller)
SATA DOM (Device-On-Module) power connectors 1/2
1-5
Chapter 1: Overview
Default Setting
See Chapter 2
Off (Disabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Normal)
Pins 1-2 (Enabled)
Pins 1-2 (Reset)
C header (for IPMI-card support)
2