Genlock Adjustment - Panasonic AW-HE100E Operating Instructions Manual

Genlock adjustment

Genlock adjustment
The genlock adjustment is performed to achieve phase
alignment by applying external synchronization (genlock)
when a multiple number of cameras will be used or when
the unit will be used in combination with other devices.
This unit supports the BBS or VBS signal as the genlock
signal.
Ask your dealer to perform this adjustment.
(Use a dual-trace oscilloscope for the adjustment.)
 Horizontal phase adjustment
Observe the waveforms of the external sync signal input
(black burst signal) and video signal output on the dual-trace
oscilloscope, and use the wireless remote control or
controller to bring the horizontal phase into alignment.
Bring the horizontal phase into alignment.
External sync signal
input (black burst signal)
Video signal output
36 (E)
When performing the operations using the
accessory wireless remote control
1
Set to the user mode by following the
steps in "Selecting the shooting modes
(scene files)" (page 19).
At this time, keep the "Mode Set" sub-menu on the
display.
 The horizontal phase adjustment is common to all
shooting modes (scene files), but when the wireless
remote control is used to perform the adjustment, the
shooting mode must be selected.
For this reason, either select the shooting mode
which will be used subsequently or select the
shooting mode again afterward.
 Halogen Mode Set 
Brightness Set
Colour Set
G/L Set
Other Set
Initialize
Return
Example: Halogen mode
2
Press the [] or [] button to make "G/L
Set" blink.
3
Press the [] or [] button.
The "G/L Set" sub-menu is displayed.
 G/L Set 
H Phase
SC Coarse
SC Fine
Return
4
Press the [] or [] button to make the
"H Phase" value blink.
5
Press the [] or [] button to change the
value, and adjust so that the horizontal
phase is aligned.
6
Press the [MENU] button for two seconds.
The menu display is exited.
+1
180deg
±0